Only about Astrophotography!
Early last week, in my quest to find the source of my elongated stars problem, I was doing research on the internet when I came across a paper by Craig Stark titled: “What to do When PHD Guiding isn’t Push Here Dummy“. In his paper, Mr. Stark discusses the possible effect of gravity on stars…
Read more
This week, the weather has been very good…it’s the fourth clear night in a row. Futhermore, I am attending a CCD conference on Saturday…what more could you ask to satisfy an astrophotographer? On October 25th, I contacted Moonlite Telescope Accessories about the broken bearing on my focuser, Ron Newman replied on the 27th telling me to ship the focuser to him and explaining…
Read more
Last night, in order to try to reduce the differential flexure problem that have been plaguing me, I replaced the guiding camera 2″ extension tube I was using with the ED80T CF with a 1.25″ diagonal with the hope to be able to move the draw-tube more into the focuser. With the 2″ extension tube, my draw-tube was…
Read more
October 20th I imaged LBN640 taking 45 X 4 minutes sub-exposures at ISO 800. Using DeepSkyStacker and Maxim DL, I did some analysis on the sub-eposures produced during the session. Here is what I found: Over the course of the 3 hours, the entire imaged drifted 38 pixels; Since my image scale is 0.812 arcseconds/pixel, the total drift…
Read more
Monday night, I decided to conduct a quick test to confirm whether or not the modifications (IR filter removal and cooling) of my Canon 350D had indeed introduced tilt of the CMOS assembly. Here is what I did: I replaced my modified 350D with my non modified 450D; Focused; Took 15 unguided images of 10 seconds each, near…
Read more
Yesterday, I took the time to disassemble the cooled 350D from the main OTA and here is what I did: Inspected the T-Ring to make sure that the central portion of the T-Ring was square with the outer ring (i.e. the central portion is maintained in the outer ring by 3 small screws). A few weeks…
Read more
After fixing the Starshoot Autoguider Camera, I re-installed everything and did some tests again (i.e. took 60, 120, 180 and 240 subs while guiding). To my great deception, all the subs showed elongated stars again. However, the elongations were not oriented in the same direction (i.e. parrallel). In the upper left, the elongation was oriented toward the…
Read more
While searching for a solution to the elongated stars in my images online, I stumbled on a Cloudy Nights thread where a gentlemen realized that his QHY5 guiding camera had a loose circuit board inside the camera. I went outside to get my Orion Starshoot Autoguider camera to investigate whether or not I might have the same issue. I…
Read more
2 days ago, I reverted back to the piggy-back installation and did a 4 minutes exposure with autoguiding enabled. I no longer had elongated stars in my images. However, with this configuration, I was unable to balance the scope in DEC due to the off-set of the stock CGEM saddle (i.e. the center of the…
Read more
Tonight here is what I did to try to fix the elongated stars in my images following the changes I’ve made on my setup: Tightened the Guider focuser tension screw Made sure everything was well screwed and solid Re-leveled the Pier 3 stars alignment with the CGEM Polar alignment with the CGEM software Lauched PHD…
Read more
